Cold Mounting Accessories
Round Moulds – Silicone Rubber
Rectangular Moulds – Silicone Rubber
Met-Moulds – Polypropylene 2 part
Silicone – Mould Release
Mixing Cups
Stirring Sticks
UNICLIP – Plastic Tripod
Specimen mounting device for holding sheet material, PCBs, wire and irregular small shapes. Tripod design to minimise interference at the prepared surface.
CLAMP Spring Clips
For mounting thin samples.
Sample Identification Labels
Specimen Protective Lacquer
Vacuum Impregnation Units
Technomat Pressure Chamber
For use with CRYSTAL-KLEER Mounting Compound to produce glass clear mounts.
Systems for Cold Mounting
KLEER-SET
Polyester resin / hardener system giving glass clear mounts. Curing time 40 mins.
TRI-HARD
3 part powder / liquid system giving exceptional hardness and low shrinkage for use in exacting applications where specimen edge retention is of paramount importance. Curing time 15 mins.
VARI-SET
Acrylic powder/liquid system offered in two different hardness levels. Powders can be mixed to obtain intermediate levels of hardness. Minimal shrinkage ensures ultimate edge preparation. Curing time 10 mins.
QUICK-SET 2
Acrylic powder / liquid system giving a fast cure time of 5 mins, combining ease of use with minimal shrinkage and low odour.
ACRI-KLEER
The most transparent powder / liquid cold mounting system, without using a pressure chamber. Curing time 8 mins.
EPO-SET
Epoxy resin / hardener system, low shrinkage. Curing time approx. 6 hours.
EPO-FLO
Extremely low viscosity epoxy system for vacumn infiltration of porous materials. Curing time approximately 2½ hours at 40-50°C. Very low shrinkage.